2. 最短高度:  initial height            

3. 最大高度:  maximum lifting height                    

4. 最大負載 :  maximum load                      

5. 自重:  self weight                      

6. 纖繩掛環： Cordelle hanged ring

7. 鎖圈： locking collar

8. 撐腿： tripod  leg

9. 撐桿： tripod  body

10. 撐桿調節套： adjusting sleeve

三、使用說明

1.將升降桿從布袋內取出，垂直置于地面上；

To take the mast from the hop-pocket, stand vertically on the ground

2.打開升降桿三腳架的三個撐腿使之平行于地面；

To open the three legs of tripod, run them parallel with the ground

3.轉動撐桿調節套使撐桿最短,這樣鎖圈處于自由轉動狀態,轉動鎖圈并鎖定； To turn the adjusting sleeves of tripod body, make the tripod body into minimum length. The locking collar is in free revolving, turn the locking collar and locks it

4.轉動調節撐桿調節套使升降桿垂直于地面；

To turn the adjusting sleeve, make the mast vertically on the ground.

5.在一個纖繩掛環上掛三個纖繩,接通氣泵；
To install three cordelles into one cordelle hanged ring, connect with the pump

6.在升降桿完全升起后,將纖繩下端栓在地面固定物上,以保持升降桿穩定； To fix the cordelles on the ground so as to keep the mast completely extend

7.將進氣管折起后可以撤除氣泵,升降桿在2kg氣壓狀態下可保持24小時以上；

To take away the pump after tucking up the air pipe. The mast can keep standing over 24 hours under 2kgs air pressure

8.用后將手動升降桿，手動升降器，手動伸縮桅桿，手動升降塔桅桿，手動升降支架收藏于布袋內。

To collect the mast into the hop-pocket after working